algorithmic modeling for Rhino
Check if points are inside or outside
Hi Guys,
I have a surface with subsurfaces and I have a closed line on the surface. I want to make a check, which midpoints are inside this curve and which ones are outside. I didn´t find it in the forum but I´m sure there must be quite a simple solution. Any suggestions?
Thanks
I have a surface with subsurfaces and I have a closed line on the surface. I want to make a check, which midpoints are inside this curve and which ones are outside. I didn´t find it in the forum but I´m sure there must be quite a simple solution. Any suggestions?
Thanks
Views: 4081
- Attachments:
-
-
Checkinside.jpg, 287 KB -
01004_Surface_Sorting_by_View.3dm.rhl, 1 KB -
checkinside_gh.jpg, 629 KB
-
Replies to This Discussion
-
Permalink Reply by Danny Boyes on
-
Hi Simon,
One way might be to use the Inside component in the Analysis Section of the Surface Tab. You would have to create a BRep from the curve to enclose the points.
Best regards,
Danny
-
-
Permalink Reply by Simon Vorhammer on
-
Danny, this is exactly what I was searching for. Thanks a lot!
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Orient On Curve
Added by Parametric House 0 Comments 0 Likes
-
Parametric Roof
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
