Grasshopper

algorithmic modeling for Rhino

Change a flat surface to a curved surface?

Hello 

I am very new to grasshopper and I am trying to curve a surface by adjusting either one or both of the edges. So the surface will start out flat and then one of the edges (or both) can be adjusted using the slider tool to make it curve upwards or downwards. 

Thanks for any help!

Views: 312

Replies to This Discussion

Permalink Reply by Michael Pryor on March 4, 2013 at 11:43am

you will get better results in the discussion forum. FAQ is for posting answers to common problems.

Permalink Reply by MARIO VERGARA on March 4, 2013 at 11:59am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service