cant create a perforated surface with lunchbox diamond grid

Replies to This Discussion

Permalink Reply by Damon on August 4, 2014 at 9:27am

I used the Split Surface component and grafted the inputs, so it was splitting each diamond surface with each inset-filleted diamond curve. The only bummer is the seam. If you look in the picture below carefully, you'll see on the side of the tower to the right-forward, there are some triangular panels with a vertical seam. You might want to work on fixing this going forward, but I think this moves you forward a step or two.

Attachments:

• dp.gh, 10 KB