Grasshopper

algorithmic modeling for Rhino

can you open a file in another program and save that file as a filetype all from a vb script in grasshopper

hi,

I am exporting obj files from gh to run in another piece of software called limitstate, however, limitstate doesnt like the way my obj files from grasshopper are written so i am fist opening my obj files in a program called meshlab and saving them again as an obj file.

Assuming i have already exported my obj filed from grasshopper, i was wondering whether there was a way to open my obj file with the program grasshopper, then save is as an obj in another file location all using a VB script written in a grasshopper component.

I am not sure if it is possible at all but if so how should i go about it....tutorials, commands i should use, precedent examples....?

thanks 

Ken 

Views: 442

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on January 29, 2013 at 1:58pm

Hi Ken,

Did you try to play with the options for export as .obj in Rhino/Grasshopper? You may be able to export an .obj file that works fine in limitstate?

Mostapha

PS: I know I didn't reply to your question but just as a side note.

Permalink Reply by Kenneth Allan on January 29, 2013 at 3:16pm

i did but i wouldnt really know what to change..... anyway. il have a go again but do you know if what i was asking is possible at all?

Permalink Reply by Mostapha Sadeghipour Roudsari on January 31, 2013 at 11:47am

Hi Ken,

To see the differences between the .obj files just open them in a text editor. It should be easy to pick the difference(s) for the same geometry.

I think it should be possible as far as you can open and control the other program from the command line.

Mostapha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service