Grasshopper

algorithmic modeling for Rhino

can't morph surface

Hi, I've created a surface and now I want to morph some things on it, but I can't divide the surface, so I can't create morph boxes... I've read that it's because it's an open brep instead of a surface, cause it's made out of polylines, but isn't it possible to morph something onto an open brep? I would like to keep the polylines and not convert them to curves.

Thanks,

 

Mick

Views: 558

Attachments:

Replies to This Discussion

Permalink Reply by Goossens Niels on October 20, 2011 at 11:57am

There's an attachment with my programming in it

Permalink Reply by Goossens Niels on October 20, 2011 at 12:12pm

I've also tried to convert the polylines to curves with something like a hundred control points, so it really matches the polylines, but even with planar curves as input, the loft command creates an open brep...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service