Grasshopper

algorithmic modeling for Rhino

can;t change wire display on PointOnCurve component

well, the title pretty much says it...
(the menu where this option usually is doesn't appear no matter where you right click on it; not exactly super important, but anyway..)

Views: 383

Replies to This Discussion

Permalink Reply by David Rutten on May 5, 2015 at 7:19am

I added the wire Display and Wire Disconnect menu items. Next Rhino WIP release should have this.

Permalink Reply by Andrei Raducanu on May 5, 2015 at 9:28am
Thankies!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service