Grasshopper

algorithmic modeling for Rhino

c# boolean split

Hi,

I have two breps fairly simple geometries:

1. tube

2. open cylinder.

In Rhino I type boolean split and I get two separate closed breps.

How to perform the same operation in C# using RhinoCommon?

Views: 901

Attachments:

Replies to This Discussion

Permalink Reply by Tomas Vinkevicius on November 5, 2016 at 11:54am

Solved it.

Was not a very linear procedure, because I had to use Brep.Split, then check each brep face if it is inside another brep. Then create a new brep.

Permalink Reply by Tomas Vinkevicius on November 5, 2016 at 12:16pm

But I would like to ask if there is a method get a point on  a trimmed surface?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service