Bundeling curves kangaroo

Replies to This Discussion

Permalink Reply by Mohamed Naeim on December 4, 2016 at 2:50am

https://naeimdesigntechnologies.wordpress.com/2014/03/20/force-fiel...

This is my experiment with bundling 

try also this 

http://www.designcoding.net/edge-bundling-test/

Permalink Reply by Madeleine on December 5, 2016 at 3:56am

Cool!

Permalink Reply by Mohamed Naeim on December 4, 2016 at 6:30am

http://www.grasshopper3d.com/video/kangaroo-curve-pull

Permalink Reply by Mohamed Naeim on December 4, 2016 at 9:21am

another version with kangaroo, not perfect but seem in the right direction 

Permalink Reply by Mohamed Naeim on December 4, 2016 at 9:23am

Attachments:

• EDGEbUNDLING02.gh, 13 KB

Permalink Reply by Madeleine on December 5, 2016 at 3:56am

Thanks a lot! I will give it a try :) 

Permalink Reply by Daniel Piker on December 5, 2016 at 8:32am

Are you after something like this?:

http://www.grasshopper3d.com/group/kangaroo/forum/topics/woolly-pat...

Permalink Reply by Madeleine on December 5, 2016 at 8:36am

This is what Im trying to create...

http://www.designcoding.net/edge-bundling-test/

Permalink Reply by Daniel Piker on December 5, 2016 at 10:02am

Isn't that roughly the same as what I linked just above?

Permalink Reply by Madeleine on December 5, 2016 at 10:03am

Yes, you are right

Permalink Reply by Madeleine on December 6, 2016 at 2:13am

I tried to use the file onmy curves, yesterday it worked out pretty well with some test curves but now the output is just turning red... I dont know what I did...

Attachments:

• Roof structure.3dm, 555 KB
• 02_WoolThreadsK2.gh, 21 KB

Permalink Reply by Madeleine on December 6, 2016 at 7:45am

See attached printscreen

Attachments:

• prtscn2.pdf, 470 KB