Bug? Shaded preview displayed as wireframe.

Replies to This Discussion

Permalink Reply by Suryansh Chandra on December 6, 2009 at 4:49pm

I also came across this case once, but it was only for one very complicated brep (with over 250 OnBrepFaces).. all other 'simpler' surfaces were showing as shaded along with this one in wireframe. However, when I baked it, Rhino displayed it correctly so I just lived with it as long as my end product was okay.

It probably is a bug but I am not sure if it can be attributed to this particular version. And it seemed to fail only for super heavy Breps..

Permalink Reply by Chris Wilkins on December 6, 2009 at 6:41pm

Yes. Mine baked properly too. Doesn't really hurt anything, but I figured it should be reported.

Permalink Reply by Luis Fraguada on December 7, 2009 at 2:05am

On most of these cases a custom preview will show the geometry shaded again.