Bug list

Hi David. A few bugs that are still in 8.0007:

1. Point parameters won't bake with the egg icon, though they will through the context menu.

2. Any paste of geometry into Rhino causes a complete solution rebuild in Grasshopper, even if geometry is unassociated with the definition. Is this intended for some reason?

3. I think this has been brought up before, but even the largest titlin' text tag is too small to be read with some displays. Any chance of size options, or some other fix?

Thanks much, and any luck tracking down the 64bit superbug yet?

Replies to This Discussion

Permalink Reply by Danny Boyes on April 5, 2011 at 9:36am

In answer to number 3: http://www.grasshopper3d.com/forum/topics/referencing-objects-in-rh...

Permalink Reply by David Rutten on April 5, 2011 at 9:46am

1. fixed

2. Looking into it.

3. this is a bug in the text-rendering function in Rhino. At the moment I cannot control the size of displayed text at all.

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by greg bethel on April 5, 2011 at 9:50am

Thanks, David. And thank you for the link, Danny, I missed that text tag discussion when I searched.

Permalink Reply by David Rutten on April 12, 2011 at 4:38am

2. I can't repeat this at all. Can you please post a file where this is the case. Also, is this Rhino4, 5 or both?

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by greg bethel on April 12, 2011 at 4:29pm

I can't add files in Ning discussions (or reply to specific posts) on firefox or ie, so I posted files here: http://www.grasshopper3d.com/profiles/blogs/paste-bug-files

It's a little trickier than I thought, but the bug is in both V4 and 5. I believe it requires processing on geometry that is referenced. Moving the wires to the non-referenced geometry and pasting anything into Rhino doesn't cause recalculation.

Permalink Reply by greg bethel on April 12, 2011 at 4:55pm

Didn't realize the offset bug got even worse and happened to use it in this example. It's not necessary and can be disabled and bypassed.

Permalink Reply by greg bethel on July 22, 2011 at 12:41pm

David, did you get a chance to check out the paste situation as described? I believe it's still present in the latest version.

Permalink Reply by David Rutten on July 23, 2011 at 3:35am

Yes, I can repeat it. I'll fix it.

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by David Rutten on July 23, 2011 at 3:40am

Fixed. It also happened when a file was imported into the current Rhino document.

David Rutten