Grasshopper

algorithmic modeling for Rhino

(Bug?) Everything looks fine in Grasshopper, but missing lines in the bake result.

Hi, not sure if this is a bug or something stupid on my part.  Making a simple Truchet pattern, but some of the lines do not bake, even though they display properly in Grasshopper (Build 0.9.0076).  Note that the missing lines are always in the center of the cells, and seem to always have the same orientation.

Truchet%202.gh

Views: 525

Replies to This Discussion

Permalink Reply by Pieter Segeren on August 30, 2015 at 2:57am

Hi Mike, no bug, nothing stupid either. To prevent the invalid (and duplicate) curves I did this:

Permalink Reply by Mike on August 30, 2015 at 8:13am

Thanks so much!

Permalink Reply by Pieter Segeren on September 2, 2015 at 2:29pm

Turns out there is a dedicated component for this kind of thing - PruneTree:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service