Grasshopper

algorithmic modeling for Rhino

SOLVED: Brep trim

Hi,

 

I am trying to trim a main brep with a series of smaller one. But, by doing so, I end up with the main brep trimmed with the smaller ones in isolation; aka 1 main brep for every smaller brep I am using as trim set.

 

What I actually want is one main brep with the smaller brep series taken out as a singular brep; aka one brep with multiple holes through it.

 

I've tried joining the smaller breps together as well as doing a boolean brep join but somehow I still end up with a series of brep trim.

 

Any help would be appreciated.

 

Thanks!

Views: 11703

Attachments:

Replies to This Discussion

Permalink Reply by John Gulliford on September 26, 2011 at 3:43pm

I have uploaded an example that works. Apply the same principles to your problem.

three tips

1. make sure Branch Paths have the same dimension.

2. flip cutting surfaces to pick what side you want to keep.

3. pass in two flattened arrays. one for cutting, one for object of cutting.

Attachments:
Permalink Reply by Nick on September 26, 2011 at 4:27pm

I am still faced with the same problem...

 

One thing I noticed is I can't flip the cutting surfaces as I am using a lofted brep, not extruded...

Permalink Reply by Yoann Mescam (Systemiq) on September 27, 2011 at 7:03am

Try Sdiff.

Permalink Reply by Nick on September 27, 2011 at 10:34am
Thank you, this seems to be working. :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service