Grasshopper

algorithmic modeling for Rhino

Brep, surface

Hi

I have a surface, but grasshopper consider it a Brep

I would like to divide the surface with isotrim

so i explode Brep and try construct a new surface, but Iso trim or lunchbox surface divider, do not divide all surface equaly.

The middle part of surface is divided, but not the end of the surface

How can i divide all surface? in more or less regular parts.? or is some fundamental wrong with the surface.

Views: 742

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on March 22, 2016 at 12:54pm

Add "Rebuild Curve" would help. Best.

Attachments:
Permalink Reply by Elisabeth on March 22, 2016 at 1:11pm

Great

Thanks a lot, i never use this rebuild curve.

You are right, i thought of problem walking the dog, and i used fillet at the curves, so the curves have more control points in fillet area.

But i did not know how to solve it, i never used rebuild curve, that is very good solution.

Great!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service