Grasshopper

algorithmic modeling for Rhino

Brep Split Failed

Hi,

I want to split one brep with another brep using split method. No matter how I scale the cutting Brep to make it big enough, the result is always empty. 

What's wrong with the geometry? They seem to be valid using IsValid property.

What's the most robust way to split one surface with another surface? Actually, I just want to split one surface with another. 

I have attached the file below.

Thank you!

-Jerome

Views: 1586

Attachments:

Replies to This Discussion

Permalink Reply by biboarchitect on July 18, 2012 at 12:17pm

I face the same issue with region intersects curves/curves, no error message, yet the result is empty.

Using Rhino 5 WIP, GH 8.0065.

Any suggestions appreciated

Permalink Reply by raf2205 on July 18, 2012 at 2:13pm

Hi Jerome, your input brep seems a bit odd. You should try to rebuild it...

Permalink Reply by Jerome on July 18, 2012 at 7:41pm

Thank you,

The problems is, the input brep is actually the result of the previous brep split command. Which means the result of the brep split may either be null or odd...

-Jerome

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service