Brep Failure

Replies to This Discussion

Permalink Reply by Thomas Bildsøe on April 12, 2012 at 1:32am

As far as I can see, the only error that shows in your definition is the Brep-Plane component failing for one plane because the plane does not intersect the brep. That is the right-most plane. Also, I'm not quite sure what you're trying to achieve, what is going to be lasercut?

Permalink Reply by Natasa on April 12, 2012 at 7:33am

Hi Thomas,

You were right I didnt realize that the curves should be sectional lines of the surface.

What I want to do is to distribute the section curves on the two production sheets related to U and V directions, so that I can offset them afterwards in order to make a parallel series of ribs to laser cut.

Permalink Reply by Thomas Bildsøe on April 13, 2012 at 1:08am

Hmmm, I'm still not sure exactly what you're trying to accomplish, but have you looked into wafflescript?

Perhaps like this:

http://www.grasshopper3d.com/forum/topics/a-solid-waffle-for-laser