Branching with Kangaroo!

Replies to This Discussion

Permalink Reply by Daniel Piker on February 18, 2014 at 10:15am

I don't think I follow what result you are aiming for.

Could you post a sketch?

Permalink Reply by Mariana Schetini Basso on February 18, 2014 at 12:41pm

It's something like this, but with branches =)

Attachments:

• print2.png, 310 KB

Permalink Reply by Victor Sardenberg on February 20, 2014 at 9:53am

Mariana, can you upload a handmade sketch you showed me. It's easier for Daniel to understand.

Permalink Reply by Mariana Schetini Basso on February 21, 2014 at 10:00am

Maybe this!!

Attachments:

• sketch.jpg, 26 KB

Permalink Reply by Daniel Piker on February 21, 2014 at 10:20am

I'm still not sure if I understand, but it seems that maybe something like DLA

http://www.grasshopper3d.com/profiles/blogs/diffusion-limited-aggre...

would be more useful to you here than Kangaroo.

Permalink Reply by Mariana Schetini Basso on April 29, 2014 at 11:12am

Hello Daniel, thanks for your reply.

We're working with some biometric sensors, each sensor will give an input for the dynamics, as attraction, repulsion, particles velocity, etc. Therefore, we need to use kangaroo for the dynamics, but I have no ideia how to create branches by subdividing these particles in order make it similar to tree branches (L-system).We were making clusters with other kangaroos that take points of the first kangaroo but sometimes it goes out of control.  Do you have any idea that could help us? 

Thanks in advance!