Grasshopper

algorithmic modeling for Rhino

branching problem

Hi there,

 

I created a definition which takes a polyline and makes filleted corners. The radius in each corner is depending of the sharpness of the corner itself. that means smaller radiuses for sharper corners.

 

This works fine for one input curve. i would like to get it to work for multiple curves. Is anyone able to help me modifying the definition in terms of trees and branches so I can input muliple curves?

 

I can´t get it done.

 

thanks in advance,

 

Simon

Views: 742

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on October 14, 2011 at 3:56pm

Use the Parameter Viewer component to get the branch paths for the multiple curves.

 

Chris

Attachments:
Permalink Reply by Simon Vorhammer on October 16, 2011 at 3:39am

Chris, thanks a lot.

That works perfectly!

Permalink Reply by Pieter Segeren on October 15, 2011 at 7:48am

Hi Simon, some of us are trying to help you, here is a discussion you'll like:
http://www.grasshopper3d.com/forum/topics/filleting-polyline-t-ques...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service