Grasshopper

algorithmic modeling for Rhino

box morph,surface doubts

Hi,

I have a doubt regarding the box morph.I am trying to create a surface which is divided along the uv direction.And from the center of each uv division i want a geometry to be morphed.I tried to a certain extent.And Im not able to get the last part of it right.

1)im having issues with the box morph and the geometry that i want to repeat in each of the uv division.

It would be of great help if someone can help me figure out whats wrong in this.Im attaching the gh file and screenshots.box%20morph%20surface.gh

Views: 1220

Attachments:

Replies to This Discussion

Permalink Reply by Ben on July 16, 2017 at 7:18pm

All the way at the end of your definition, you don't need to find the center points of each surface from the isotrim. If you plug the isotrim surfaces straight into the T input of the box morph it will solve your problem. I attached a .gh with this change, and the scale of the boxes might be a little weird but you should be able to continue to manipulate them once they are mapped onto your surface.

Attachments:
Permalink Reply by sruthi on July 19, 2017 at 9:09am

Thank u sooo much !! Its really helpfull :)

Permalink Reply by Hyungsoo Kim on July 17, 2017 at 1:14am

Hi.

Why don't you use "Surface Box" instead of "Isotrim"?

Attachments:
Permalink Reply by sruthi on July 19, 2017 at 9:09am

Hii!! Thank u sooo much ..!! Will try it out !! Its really helpful :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service