Box Morph in diagrid

Hi:

I am using a great definition of a diagonal diagrid, made by LaN - Live Architecture that I found on their web site, which I recommend (http://www.livearchitecture.net/), and I am trying to combine it with a box morph definition that I have made, but the results is not working.

I am using as a surface domain the 4 pt surface given by diagrid defintion but is not working.

Can anyone help me in how to proceed?

Thanks

Attachments:

Diagrid Box Morph.3dm, 111 KB
Diadrig box morph.ghx, 297 KB

Replies to This Discussion

Permalink Reply by Mirco Bianchini on January 11, 2011 at 7:45pm

Attachments:

Diadrigboxmorph Variation.ghx, 781 KB

Permalink Reply by Fernando Rial on January 12, 2011 at 5:39am

Hi Mirco:

Thanks a lot. This really helps.

I was looking for a separation between the romboids but with your definition maybe I can control this gap with the slider maybe (something like in the image)

Attachments:

Diagrid Box Morph what I look for.jpg, 193 KB

Permalink Reply by Mirco Bianchini on January 12, 2011 at 6:35am

Hi Fernando,

perfect, let me know.

Permalink Reply by Fernando Rial on January 13, 2011 at 1:36pm

Hi Mirco:

This is what I look for. The definition works in a rectangular surface but I can not make it work in non regular surface. I have no clue why.

Attachments:

what I look for.jpg, 446 KB

Permalink Reply by Mirco Bianchini on January 13, 2011 at 4:38pm

Hi Fernando

perhaps I understand where is the problem.

I work it.

Permalink Reply by Fernando Rial on January 16, 2011 at 3:31pm

Hi Mirco,

I think that the problem is the surface from rhino, the u and v direction. I´m working on it trying to generate a surface in rhino with appropiate uv direction in order to apply the definition succesfully.

I´ll let you know about my improvements.

Permalink Reply by Dedackelzucht on January 14, 2011 at 3:00am

Mh maybe without boxmorph? :-)

Attachments:

DiagridBoxMorph_Johannes.3dm, 86 KB
101230_quad_diagrid[autosave].gh, 59 KB

Permalink Reply by Fernando Rial on January 16, 2011 at 3:26pm

Hi Dedackelzucht:

Thanks for the help, but I don´t know if I can control a mesh as much as a surface. I mean, it is just a matter of my knowledge. I´ll try it out and let you know.

Permalink Reply by Dedackelzucht on January 17, 2011 at 1:50am

I think with rhino membrane it should work? Otherwise send me the surface and I give it a try :-)

Permalink Reply by Fernando Rial on January 17, 2011 at 2:30am

Hi:

Here it goes the surface.

Thanks!

Attachments: