Grasshopper

algorithmic modeling for Rhino

Blending geometry

Hi All,

Can someone refer me to a way to blend geometry in grasshopper. The attached image is done in rhino using a loft command between the geometry and then contour. I am also trying to control the number of steps and the distances between the geometry blending to gain different variations of resolution. Please help :)

Views: 561

Replies to This Discussion

Permalink Reply by Rajaa Issa on January 18, 2016 at 8:41am
Barrak. I Rhino, TweenCurves will give you this result. In GH, you have better control over curves and spacing. For example you can vary the number of edges in a polygon and distances. Does that help?
Permalink Reply by Barrak on January 18, 2016 at 3:33pm

That is exactly what I was looking for,,Thank you!

Permalink Reply by Michael Riggin on January 18, 2016 at 4:44pm

Just a side note Barrak, a quick way to test some values for this is by using the Gene Pool component in the Galapagos portion of GH, which will act as a series of sliders. See the attached example.

Attachments:
Permalink Reply by Barrak on January 18, 2016 at 6:58pm

thank you mike its a very helpful and practical component!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service