Bending a mesh surface in Kanagroo

Replies to This Discussion

Permalink Reply by Jacek Jaskólski on November 23, 2011 at 3:45pm

I would suggest you first deform the plane surface, not the actual mesh itself, then use 'surface morph' to bend the original crack pattern mesh.
(this may be very slow as your mesh is quite tesselated, but still rocket fast compared to passing the original mesh through kangaroo...) 

 

Permalink Reply by Kayleigh Dickson on November 23, 2011 at 4:29pm

Hi Jacek,

 

Thank you I will give it a go and hopefully it will work out.

 

Thanks