Grasshopper

algorithmic modeling for Rhino

Basics: evaluating curves

hi,

i draw a curve, but it is not parametrized from 0-1.

is there a base that curves are evaluated this way automatically after its creation?

for example if i try to find the midpoint of a curve i usually have to evaluate the curve at parameter 0.5.


bg
morphedian
http://morphedian.blogspot.com/


Views: 5218

Replies to This Discussion

Permalink Reply by morphedian on May 4, 2010 at 3:51am
"point on curves" automatically uses a parametrization of 0,1, cool.

bg
morphedian
http://morphedian.blogspot.com/
Permalink Reply by Martin Wyss on May 4, 2010 at 6:19am
otherwise just right click on the C-input of the "evaluate curve"-component and check reparametrize! then the curve will be parametrized from 0 to 1.
Permalink Reply by morphedian on May 4, 2010 at 6:42am
thx for that, unfortunatly i´ve overseen this option!

:)

bg
morphedian
http://morphedian.blogspot.com/

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service