Basic Curve loft problem

I cannot get 'Normal' smooth curve lofts through GH, despite adjusting the 'loft options' in the GH component. This is probably a very basic user error, but I've been trying to solve it for way too long now. Curves loft 'Normal' according to loft options in Rhino, just not thru GH logic. Does anyone have any advice?

Thanks, Matthew

Replies to This Discussion

Permalink Reply by Sam75 on March 29, 2011 at 12:20am

you are talking about the resolution of the displayed mesh in gh ? if so you can work with bigger units

Permalink Reply by Matthew Schexnyder on March 29, 2011 at 7:04am

Yes, the resolution of the displayed mess thru GH is not as smooth as compared to the mesh lofted purely in Rhino. Maybe 'units' is the problem; I am working in inches in Rhino. Thanks for your reply.

Permalink Reply by Sam75 on March 29, 2011 at 7:59am

once backed into rhino it will be as smooth as other rhino surfaces, but for visualization purpose you can use a "mesh brep" component and connect to S a "settings (quality)" component, or a custom one if not good enough, this is what I do.

Permalink Reply by Matthew Schexnyder on March 29, 2011 at 9:20am

OK. That makes sense. Thanks very much for your explanation. Best Regards, Matthew

RSS