Basic Attractor Point Question

Replies to This Discussion

Permalink Reply by Mateusz Zwierzycki on March 28, 2012 at 8:59pm

remap values component

Permalink Reply by Matt Kraft on March 28, 2012 at 9:48pm

What does that mean?

Permalink Reply by Michael Pryor on March 28, 2012 at 10:31pm

remap component. check out this way I made that has a switch to go between a repeller(what most people mislable as an attractor) and an attractor. http://formularch.blogspot.com/2012/03/gh-point-attract-repel.html?m=1

Permalink Reply by Matt Kraft on March 28, 2012 at 11:25pm

This is the definition Michael....

Attachments:

• Color Boxes.ghx, 205 KB

Permalink Reply by Michael Pryor on March 29, 2012 at 12:03am

look here. In the future it is best to not make 2 posts about the same thing. http://www.grasshopper3d.com/forum/topics/exercise-9-3?id=2985220%3...

Permalink Reply by babym on October 20, 2012 at 1:41pm

Hi Michael! Quick question, you link was very useful! but what if instead of controling the cirles radius I actually want to move (distance) the points that are being repelled so that the voronoi pattern (shown below) is affected?? Any ideas?

Attachments:

• Voronoi Repel Point.png, 403 KB

Permalink Reply by Michael Pryor on October 20, 2012 at 2:26pm

Then use move and vector 2 point

Permalink Reply by babym on October 20, 2012 at 3:30pm

I'm sorry but I'm new at this.. what should I connect those components to? I've been experimenting but I cant quite figure it out 

Permalink Reply by djordje on October 20, 2012 at 4:17pm

Babym, I may misunderstood you.
But, is this what you want to achieve:

?

P.S.

Michael thank you for learning the difference between these two terms, and the way repeller can be achieved.

Attachments:

• voronoi repeller.gh, 5 KB
• voronoi repeller.3dm, 52 KB

Permalink Reply by babym on October 20, 2012 at 4:30pm

Hi Djordje, 

Thanks for your response, but instead of creating different sizes in the offset, I wanted to the actual points generated through the PopGeo component to repel themselves, so that as you get farther away from the repeller point you get a smaller scale in the pattern.. seeing as there are more points for the voronoi component.. 

I don't know if that clears it up?

Permalink Reply by djordje on October 20, 2012 at 4:45pm

Hm, just like Michael said: 2 point vector and Move:

Attachments:

• voronoi-repeller2.gh, 6 KB

Permalink Reply by Michael Pryor on October 21, 2012 at 1:02am

Attachments:

• movepoints.gh, 7 KB