baking bug

Replies to This Discussion

Permalink Reply by David Rutten on November 27, 2012 at 2:26am

Hi Joao,

it's most likely due to Meshing settings. Change your Rhino meshing settings until it works properly. Unfortunately there's no one settings that always works, you'll have to fiddle with it.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by jl on November 27, 2012 at 7:02am

Thanks for the reply David, will try

Permalink Reply by Homer Garcia Santana on November 27, 2012 at 7:35am

Joao,

I had once the same problem...here is some help to fix it.

http://www.grasshopper3d.com/forum/topics/help-two-joined-curves-still