Attempt to write my own grillage definition but... NEEDS HELP please ><

Hi everyone, I have attempted to write a definition that gives me the sections and then offset it, then create end points for both curves to join those end points up for a planar surface. the definition works fine with a surface ive been making but when I change it to another similar surface, the data matching for the end points wont match up and acts crazy!!

can any experts please shed some light in this situation when the same definition is used to two different surfaces? i dont understand how different those two surfaces are from each other that will cause this data matching to go off...

I've been flattening the list / short list / long list / cross referencing but nothing seems to work... please let me know why this is happening?

Thank you.

Grillage%20attempt.ghx

grillage%20attempt.3dm

I'v

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on December 5, 2011 at 9:38pm

Using Clean Tree on section curves should help.

Permalink Reply by Jacky Lee on December 5, 2011 at 10:26pm

OMG thank you so much!! but i used clean tree after the end points and before the flatten. not sure if thats the right way but nevertheless you are super awesome!!! thank you heaps :D

RSS