Grasshopper

algorithmic modeling for Rhino

Array and change of scale at once

Here is a snap shot of what I am trying to do in Grasshopper. I already did it in Rhino but would love to get a feedback on how to do it in Grasshopper parametrically. Where all the lines on the right and left side of the center line are an array that change in scale.

I think I know how to do it by doing it line by line, but am wondering if there is a fast way

Views: 2967

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on January 27, 2013 at 5:52am

Attachments:
Permalink Reply by Mohanned Iskanderani on January 27, 2013 at 7:34am

Dude, you are just amazing. Thank you so much

Permalink Reply by Chris Tietjen on January 27, 2013 at 7:51am

Knowledge is also a question of scale...not as amazing as you might think but probably helpful.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service