Grasshopper

algorithmic modeling for Rhino

Arc with fixed radius

Hi,

I am trying to construct an arc knowing the startpoint + endpoint + radius.

If I use the start/end and direction command (arc SED) it will not be enough as the arc obtained will not have necessarily the fixed radius I would like. If instead I use the plane/radius/angle command the re4sult will not necessarily pass through the endpoint.

I managed to do this with the Rhino command "arc by startpoint + endpoint + radius" and then assigning an orientation and this works!

Any way to do this in grasshopper?

 

many thanks

 

 

Views: 722

Replies to This Discussion

Permalink Reply by Wiet Mazairac on July 1, 2010 at 10:09am
try this
Attachments:
Permalink Reply by Wiet Mazairac on July 1, 2010 at 1:08pm
this should do it
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service