Grasshopper

algorithmic modeling for Rhino

Altering triangular / hexagonal panelling to uniform member length.

Hi everyone,

I'm a newcomer to grasshopper, just wondering if there is any way of altering a surface (an asymmetrical dome-style pavillion)[image attached] so that the members used throughout the structure are of uniform dimension. Is there a way of this member uniformity altering the original geometry?

If anyone is unsure about an exact solution but could provide a strating point it would be greatly appreciated.

Also attached is the triangulated structural form that I am looking to make uniform.

Ryan.

Dublin School of Architecture.

Views: 1971

Replies to This Discussion

Permalink Reply by taz on April 16, 2012 at 5:03pm

Arthur did a lot of work with asymmetrical gridshell creation.  You could look at his website:

http://arthurmani.com/mesh-maker-from-curves-intersection/

Also Google search "gridshell" for this site and a lot will come up...

Permalink Reply by taz on April 16, 2012 at 5:07pm

Or check out Kangaroo and equilateralization for alternate ideas:

http://www.grasshopper3d.com/group/kangaroo/page/example-files

Permalink Reply by Ryan Hughes on April 17, 2012 at 3:45am

Thanks very much Taz, will check these out now.

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service