algorithmic modeling for Rhino
align/move end point of curves
Hello everyone,
I have several round storeys (curves) which i would like to divide into equal amounts of segments to later connect (the points of) the floors with polylines that can serve as railings for sunshade.
However, it occurs that the endpoints of the curves are random so that the divided segments are far from being able to be connected nicely.
Is there someway to correct the problem so that the segments are properly aligned and can be properly connected?
Best regards,
Fred
Views: 2570
- Attachments:
-
-
end points of curves.PNG, 26 KB -
segements not above each other.PNG, 44 KB
-
Replies to This Discussion
-
Permalink Reply by Hyungsoo Kim on
-
I suppose you should adjust curve seams first by using "Seam" component.
If you can post your definition(with your curves internalised), I'll look into it.
-
-
Permalink Reply by F Eng on
-
heres the .3dm file, the gh one is attached above, thanks! I'll try in the meantime.
- Attachments:
-
-
new tools - not.3dm, 81 KB
-
-
-
-
You did not post your GH file yet.
-
-
-
my bad. here it is.
- Attachments:
-
-
new tools - not.gh, 17 KB
-
-
-
-
Like This?
- Attachments:
-
-
newtoolsnot_re.gh, 20 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Pipe Pavilion
Added by Parametric House 0 Comments 0 Likes
-
Ring Pattern
Added by Parametric House 0 Comments 0 Likes
-
Point Attractor
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
