Grasshopper

algorithmic modeling for Rhino

About sweep 2

I continue to use sweep 2 to generate a voronoi planar into landscape.

As you can see from the components that I can only work out when the controlling figure is 3 in the red circle,

but for 0,1,2,4 it did not show the surface,as you can see in the pic 1.

In the pic 2, the complete surface on the right is 3, and the left is 4.

Views: 611

Attachments:

Replies to This Discussion

Permalink Reply by maxleach on December 25, 2012 at 8:04am

DingDing

Permalink Reply by Chris Tietjen on December 25, 2012 at 7:35pm

Attachments:
Permalink Reply by maxleach on December 25, 2012 at 10:08pm

Thank you! I worked on it for several hours and finally I think it is because of Centro

Permalink Reply by Chris Tietjen on December 26, 2012 at 5:08am

No, actually it most often fails because of closed rails so the work around is to open the rails by a small amount.

Permalink Reply by maxleach on December 26, 2012 at 7:40am

Attachments:
Permalink Reply by Chris Tietjen on December 26, 2012 at 8:48am

Permalink Reply by maxleach on December 26, 2012 at 8:52am

I see I

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service