Grasshopper

algorithmic modeling for Rhino

About sweep 1/2

I was trying to create a surface by 2 circles and 1 3-point curve.

I was trying to use sweep 2, but it does not work.

1st Pic is my components and 2nd is the rhino view.

Views: 534

Replies to This Discussion

Permalink Reply by Chris Tietjen on December 24, 2012 at 1:08pm

Your section curve has to be at the start/end points of the rail curves.

Permalink Reply by maxleach on December 24, 2012 at 7:22pm

Thank you! I have done it with your help.

Merry Christmas!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service