Grasshopper

algorithmic modeling for Rhino

about nesting and reorienting faces of repeated geometry

I try to learn how to reorienting and nesting repeat geometry, but the results was different with i thought and taught in the book, I try to flip the normal of faces and do something else, but i cannot fix it to be all spread in order. the problem i think is the order of vertices dose change because the attractor or some reason. is there any pro can help me to make it right? I will be very appreciated.         ! )

ideal result 

but result is 

Views: 495

Attachments:

Replies to This Discussion

Permalink Reply by Tian on June 24, 2016 at 12:34am

hope some one can give a guide 

Permalink Reply by Hyungsoo Kim on June 24, 2016 at 2:01am

There is another easier way but, it's not good always in terms of learning.

You'll need "TTToolbox" plug-in's "Unfold" component.

Attachments:
Permalink Reply by Tian on June 24, 2016 at 5:16am

BUT IF I USE THE traditional way to do it where can i improve ?

'

Permalink Reply by Tian on June 24, 2016 at 5:17am

where is wrong with the diagram, why it came out the wrong way 

Permalink Reply by Hyungsoo Kim on June 24, 2016 at 5:47am

I guess you have used the wrong planes. See red group.

Attachments:
Permalink Reply by Tian on June 24, 2016 at 7:29am

thanks!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service