Grasshopper

algorithmic modeling for Rhino

About giving a colour to a closed curve (for example) circle

It's not like I'm just asking you to give me an answer ...

I read in GH Primer on page 61, but it seems too complicated and much more than that, what I really need, to get the job done.

I also tried to "Extrude Curve" in the direction of the midpoint of the circle. BUT, it is not nice and smooth ... Look at this:

First: There exists a "radius" (again! :D) ... Second: The colour doesn't fill the whole area ... So I ask myself while I'm discovering your beautiful program, if there is any possibility to get a colour inside the whole area with the help of GH?

AND: I tried the search button!!!!!!!!!!!!!!!!!!!! :)

Views: 951

Replies to This Discussion

Permalink Reply by Danny Boyes on April 30, 2013 at 5:57pm

This is all about render mesh quality.

Just to the top right corner of the canvas you should see a blue sphere that allows you to pick the quality of the render mesh. Change this to high

Permalink Reply by Ahmed Hossam on April 30, 2013 at 6:02pm

It worked like magic ... But this radius makes me unhappy ... Is there some method to get rid of it? ... Thank you ...

What's "mesh"?! ... I keep reading this over and over again ... 

Permalink Reply by Danny Boyes on April 30, 2013 at 6:12pm
Permalink Reply by Michael Pryor on April 30, 2013 at 6:37pm

:)

Permalink Reply by Ahmed Hossam on May 1, 2013 at 2:44am

Thank you!!! :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service