Grasshopper

algorithmic modeling for Rhino

A problem/Ladybug_Sunlight Hours Analysis

Hello everybody,

I'm a beginner on Ladybug. I have been practising Ladybug by watching all videos on Youtube. But there is a small problem showed up. When I was setting up point for textpoints, the points which were supposed to show up on the Rhino didn't show up and I thought It's probably because I didn't link sunvetors but, after I linked sunvectors to Sunlight Hours Analysis, the programme stopped working. I don't know how to solve this one. I'm currently using 0.0.62 ver and the lastest one of grasshopper. Thanks for reading :D

Views: 321

Replies to This Discussion

Permalink Reply by Misung Kwon on April 5, 2016 at 11:51am

As well as this problem, when I linked 3D tag to sunpositions and info, the texts didn't show up next to the sun. Does anybody know this problem (I'm just a beginner, so I might not have used the function properly....)

Permalink Reply by Mostapha Sadeghipour Roudsari on April 5, 2016 at 2:05pm

Misung,

Send your question to Ladybug discussion group: http://www.grasshopper3d.com/group/ladybug/forum

In your case it looks like you're missing sunVectors. Click on the balloon to see the warning message.

Permalink Reply by Misung Kwon on April 6, 2016 at 12:45am

Thanks for replying! I'm really grateful of this programme, Mostapha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service