Grasshopper

algorithmic modeling for Rhino

a closed crv

Hi there i am trying to create a close crv from points that extracted from a circle. But somehow I been not able make a closed crv but an open one. I am pretty sure there is an issue for points to form a crv directly. Is there anyone know what I should add? Cheers

Views: 3170

Replies to This Discussion

Permalink Reply by Michael Pryor on April 28, 2013 at 9:39pm

make p input of curve component to true. 

Permalink Reply by Ivan Lo on April 28, 2013 at 10:16pm

Thank you so much :)

Permalink Reply by Hadiz Ferati on November 20, 2013 at 7:45am

how did i get this CRV ?

Permalink Reply by Nick on November 20, 2013 at 8:50am

I believe that is the Interpolate Curve component

It is found under Curve / Spline's drop down tab

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service