3D Voronoi On Poly Surface

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 26, 2014 at 10:27am

There are other components(Trim solid, Solid Difference..) under the intersection tab which can help you to get your final result. Check out attached image.

Permalink Reply by Greg Kore on November 27, 2014 at 7:45am

Hey sorry i am confused by there

where did you get the initial geometry did you set it from surfaces you made in rhino?

Permalink Reply by Hyungsoo Kim on November 27, 2014 at 9:54am

I had made myself that poly-surface in rhino just imitating your image.

(2 half sphere + 1 cylinder join)Nothing special.

Permalink Reply by Greg Kore on November 27, 2014 at 10:04am

Hey 

Yea sorry i set it up like you did there and it worked  

I originally made those in rhino too i was just confused before i set it all up like you had it

so if i want to explane on that shape would that be possible to just get it as that original geometry and do that same? 

thanks for the quick response