Grasshopper

algorithmic modeling for Rhino

3d printing a GH gyroid

The attached Gyroid picture is made up of 1518 closed meshes. Produced by the  attached script. If I were to print this Gyroid ?

1. What's missing to make a 3d printed object? (besides a 3d printer)  :)

2. Do I have to clean up the 1518 closed meshes and make them 1 mesh ?

3. What to do about thickness ? etc.

Views: 15558

Attachments:

Replies to This Discussion

Permalink Reply by Ali Bazazan on March 17, 2016 at 6:12pm

so much thanks! 

Permalink Reply by Laurent DELRIEU on March 18, 2016 at 3:15pm

Thanks all for your contributions, I did some experiments, cut the gyroid to have edges on a sphere. I used quite the same script as here http://www.grasshopper3d.com/forum/topics/help-15?xg_source=activity,

Remeshing was done with MeshMixer. Cocoon was used but not the refinement. I smooth the mesh with Laplacian Smooth.

Permalink Reply by Kim hauer on March 20, 2016 at 2:38pm

Laurent: I like it......I also have a few Gyroid scripts lying around.

https://vimeo.com/159532580

Permalink Reply by Birk Binnard on March 20, 2016 at 4:46pm

Laurent - most excellent! But - how to print it?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service