Grasshopper

algorithmic modeling for Rhino

3d curved surface to flat

I have created a complex set of 3d curves and I would like to attach adhere a skin to one side of each of the curves. Do to the nature of the skin I need to cut it out of a flat sheet. Is there a simple way in kangaroo to create a flat from the 3d covered surface?  I have tried to use the rhino command “squish” any other ideas. 

type of curves i am trying to put film on one side

Related image

Views: 989

Replies to This Discussion

Permalink Reply by John on March 30, 2017 at 1:57pm

First Kangaroo works with meshes.

If you convert these stripes to develop-able mesh stripes you can unroll with kangaroo stripper component.

As long as these are just some loft surfaces, rebuild them to developable surfaces and unroll with either rhino unroll function or similar component from gh.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service