2 questions

Replies to This Discussion

Permalink Reply by Danny Boyes on June 11, 2013 at 2:37am

When you hover over the input for the dimensions of the rectangle you will see that it requires a domain. So you can draw a rectangle anywhere in relation to a plane but you need to supply a start and end. for it to be centred on the plane origin it would need to be -ve and +ve in equal measure.

What I like to do is have Expressions on [Construct Domain] -A/2 and B/2 which means you can supply a length and have it distributed equally either side of the origin

Permalink Reply by Danny Boyes on June 11, 2013 at 2:41am

Other ways to get the same result

This is the most efficient, but like anything in Grasshopper there is more than one way to skin a cat. 

Permalink Reply by Dj Splitter Pro on June 11, 2013 at 2:54am

prefect, thanks!