Grasshopper

algorithmic modeling for Rhino

{0} Branch Addressing, Maintaining Tree Structure through simplify even when only operating on one branch?

How do you make sure that the initial branch address is maintained through simplify?

Working on:

{0}

{1}

But only working on Branch {0} on its own in an operation which uses simplify. Makes new branches, that is with one digit address, i.e. {0}{1}{2} and ignores its {0} address - This then creates a branch that already exists but are not being used until later on.. The new {1} will clash with the original {1} branch when I bring the assembly back together.

Q. Is there a way to graft up, so that the principle branch is maintained?

J

Views: 876

Replies to This Discussion

Permalink Reply by Jonathan Sheridan on October 31, 2017 at 8:59am

Thanks. I hope I've been approaching this in the wrong way as I want GH to be able to handle this work.

J

Permalink Reply by Jonathan Sheridan on November 13, 2017 at 1:39am

Will this config do the job?

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service