algorithmic modeling for Rhino
Robert Hillman's Discussions (3)
| Discussions Started (3) | Replies | Latest Activity |
|---|---|---|
Lofting between edge curves of trimmed surfaces?Hi everyone, I'm just trying to loft between the edge curves of two trimmed surfaces. Basically I wanted to extrude one double curved surfa… Started by Robert Hillman in Discussion |
0 | May 12, 2013 |
Trim surface with curve?Hi everyone! I'm trying to trim a surface with a series of ellipses because I need to create the facade of the following building for an as… Started by Robert Hillman in Discussion |
1 |
Apr 5, 2013 Reply by Ralf Lindemann |
Trying to make a paper clip net??Hi there, I'm looking at paper clip nets (shown below) and trying to simulate them in grasshopper/kangaroo however i am new to both of thes… Started by Robert Hillman in Discussion |
0 | Mar 27, 2013 |
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
-
Contour Chair
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
