Fanny Y's Discussions (13)

View

Discussions Replied To (8)	Replies	Latest Activity
"And the floor plates may have an irregular shape, not rectangular. How to adopt that…" Fanny Y replied Apr 20, 2014 to geco-ecotect: how to create shadows on floor plate instead of the ground plane by varying the input mesh?	1	Apr 20, 2014 Reply by Fanny Y
"just discovered any surfaces created in rhino using "polyline" and then"planarsrf" (…" Fanny Y replied Apr 19, 2014 to when I perform "map to surface" function, why there are gaps between the output curves?	5	Apr 19, 2014 Reply by Fanny Y
"Ha that's the trick, thanks!!" Fanny Y replied Apr 19, 2014 to when I perform "map to surface" function, why there are gaps between the output curves?	5	Apr 19, 2014 Reply by Fanny Y
"here are the files thanks" Fanny Y replied Apr 19, 2014 to when I perform "map to surface" function, why there are gaps between the output curves?	5	Apr 19, 2014 Reply by Fanny Y
"I am using rhino 5, 64 bit grasshopper 0.9.0075 millipede March2014F" Fanny Y replied Apr 18, 2014 to millipede cannot load c#	3	Aug 29, 2015 Reply by Gabriella Rossi
"Thanks, remesh component works" Fanny Y replied Apr 18, 2014 to how to clean up kangaroo/weaverbird mesh edge	5	Apr 18, 2014 Reply by Fanny Y
"Thanks for reply, but I can't find this button in the Kangaroo panel. How can I find…" Fanny Y replied Apr 18, 2014 to how to clean up kangaroo/weaverbird mesh edge	5	Apr 18, 2014 Reply by Fanny Y
"I tried the uto's mesh edit tool "weld vertices" but that doesn't seem help much" Fanny Y replied Apr 18, 2014 to how to clean up kangaroo/weaverbird mesh edge	5	Apr 18, 2014 Reply by Fanny Y