Grasshopper

algorithmic modeling for Rhino

Daniel Piker's Discussions (1,808)

Search Forum

View

Discussions Replied To (1017) Replies Latest Activity

"yes, it wasn't until I started it that I realized the intersection components in gra…"

Daniel Piker replied May 9, 2013 to contain 3d voronoi within polysurface (from relaxed mesh)

 9 Nov 26, 2015
Reply by TS

"It is probably easier to make a surface from the curves with them all in the same pl…"

Daniel Piker replied May 9, 2013 to kangaroo tensile

 25 Nov 19, 2015
Reply by Nik Willmore

"Here's a solution using the mesh for the intersections."

Daniel Piker replied May 9, 2013 to contain 3d voronoi within polysurface (from relaxed mesh)

 9 Nov 26, 2015
Reply by TS

"Hi Joshua, Is it just the edges of the voronoi cells that you are after ? If that is…"

Daniel Piker replied May 9, 2013 to contain 3d voronoi within polysurface (from relaxed mesh)

 9 Nov 26, 2015
Reply by TS

"If you can get an initial division of the surface (allowing the faces to be twisted)…"

Daniel Piker replied May 7, 2013 to Planar remeshing

 6 Sep 10, 2014
Reply by Ramboll Computational Design

"You can always make a parallel planar offset, but for quad meshes, this will general…"

Daniel Piker replied May 6, 2013 to Offsetting and Scaling Facet Dome Panels

 14 May 6, 2013
Reply by Daniel Piker

"I'm glad I'm not the only one to whom that icon primarily suggests a fried egg (perh…"

Daniel Piker replied Apr 30, 2013 to Where is the Receiver?!

 33 Mar 29, 2017
Reply by Armin Seltz

"Exoskeleton is intended more for when you have a load of lines and no connectivity i…"

Daniel Piker replied Apr 12, 2013 to Voronoi difficulty.

 11 May 4, 2013
Reply by LEE

"http://www.nieser-berlin.de/research/bib/2010_NieserPalaciosPolthierZhang_HexCover.p…"

Daniel Piker replied Apr 11, 2013 to P-Hex mesh starting from mesh (instead of a surface)

 3 Apr 11, 2013
Reply by Daniel Piker

"As your surface has some anticlastic curvature, it is impossible to cover it with he…"

Daniel Piker replied Apr 10, 2013 to P-Hex mesh starting from mesh (instead of a surface)

 3 Apr 11, 2013
Reply by Daniel Piker

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service