Grasshopper

algorithmic modeling for Rhino

Joseph Oster's Discussions (2,584)

Search Forum

View

Discussions Replied To (2570) Replies Latest Activity

"The 'X' vector can be replaced by 'Y', Z' or any arbitrary vector direction. The "…"

Joseph Oster replied Aug 27, 2015 to line centered in a point

 8 Aug 27, 2015
Reply by mari

"Sounds great, and while there may be very good reasons for user accounts, I don't be…"

Joseph Oster replied Aug 25, 2015 to Send data between definitions with GeometryBin

 13 Aug 26, 2015
Reply by Ryan Gathmann

"Brilliant, I love it! What is the reasoning behind having all bins public?  Why not…"

Joseph Oster replied Aug 25, 2015 to Send data between definitions with GeometryBin

 13 Aug 26, 2015
Reply by Ryan Gathmann

"If you disconnect the 'Plane (P)' input to 'BBox', the 'DeBrep' error goes away... A…"

Joseph Oster replied Aug 24, 2015 to Bounding Box Error With Flat Surfaces

 1 Aug 24, 2015
Reply by Joseph Oster

"See this thread (among many others, I'm sure): http://www.grasshopper3d.com/forum/to…"

Joseph Oster replied Aug 24, 2015 to Brick pattern

 11 Aug 27, 2015
Reply by peter fotiadis

"Here's a way that uses a list of scale ratios and a "gap" setting: "

Joseph Oster replied Aug 18, 2015 to Repeat object with constant offset but increasing scale in one direction

 5 Aug 21, 2019
Reply by raul higuera

"Well...  The first thing that occurs to me is scaling the section based on the radiu…"

Joseph Oster replied Aug 15, 2015 to Matching Start and End of MeshSweep Section Curve

 7 Aug 15, 2015
Reply by Joseph Oster

"That's because the radius of the curve is too small at that point for the size of th…"

Joseph Oster replied Aug 15, 2015 to Matching Start and End of MeshSweep Section Curve

 7 Aug 15, 2015
Reply by Joseph Oster

""higher resolution"?  That doesn't sound likely to me, since NURBs have no resolutio…"

Joseph Oster replied Aug 15, 2015 to Matching Start and End of MeshSweep Section Curve

 7 Aug 15, 2015
Reply by Joseph Oster

"There is no trick required, as far as I can see...  But I don't have the 'MeshSweep/…"

Joseph Oster replied Aug 15, 2015 to Matching Start and End of MeshSweep Section Curve

 7 Aug 15, 2015
Reply by Joseph Oster

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service