Grasshopper

algorithmic modeling for Rhino

Surface Panelling...

Hi,

I've been getting to grips with GH over the last couple of days, and not doing too badly... so i thought.

Could anybody help point out where i've gone wrong with the attached definition please?

It's intended to be a lofted surface comprised of a series of 4-sided panels. There is one definition for the shape of the surface, and another for the panel detail.

The problem arises when i try to combine both definitions to get the panels to take the form of the lofted surface. Rhino just freezes. My file should explain more...

I've tried LOADS of alternatives, but as yet been unsuccessful.

Any tips/advice/help is very much appreciated,

Thanks in advance,

David.

Views: 1494

Attachments:

Replies to This Discussion

Permalink Reply by dcay on September 5, 2009 at 8:26am
hi,

maybe this helps... u still have to figure out how to do a offset of the polyline...
Attachments:
Permalink Reply by Stuart Fingerhut on September 6, 2009 at 2:58am
cool, thanks for sharing.
Permalink Reply by David Wood on September 8, 2009 at 8:58am
Thanks a lot for your help dcay.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service