Grasshopper

algorithmic modeling for Rhino

Transfer Line Load to a Shell

Hi, I am trying to transfer a line load to a shell element without having the line element influence my results. For instance, I can’t optimize my shell cross-section for displacements as they include my line element. Any way I could implement a line load and disregard the beam element in the analysis?

Thank you,

Mathieu

Karamba 1.3.1
Rhinoceros 6

Views: 210

Replies to This Discussion

Permalink Reply by Karamba3D on October 18, 2018 at 12:12pm

Dear Mathieu,
you could try the following: use short truss elements (beams with ‘Bending’ = false), and integrate them into your shell mesh using Karamba3D’s ‘MeshBreps’-component. Their cross sections need to be very small, so that they do not influence the response of the shell. Then place a line-load on the truss elements. This should lead to nodal loads on the shell elements which are equivalent to a line-load.
Best,
Clemens

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service