Grasshopper

algorithmic modeling for Rhino

Movement along a path (curve?) constrained by 2 points

I have attached an .mp4 of something originally done step at a time in Rhino only.

I want to be able to do this in GH where the daggerboard is constrained to travel thru 2 points at the top and bottom of the hull and it aligns itself to pass thru those points as shown in the .mp4 as it goes up and down

Any ideas or hints appreciated

Views: 541

Attachments:

Replies to This Discussion

Permalink Reply by Pieter Segeren on November 1, 2016 at 8:34am

Hi Richard, here's some hints:I used an arc with radius = hull height to find the point on the daggerboard, then used an Orient component to get the daggerboard in the right position/orientation.

Permalink Reply by Richard Roake on November 1, 2016 at 2:45pm

thanks, I'll give that a try :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service