Error

Hi Everybody,

How can I solve this error?

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on September 23, 2016 at 7:47am

Check if the EnergyPlus simulation ran correctly.

Permalink Reply by sajad shahin on October 7, 2016 at 3:54am

Hi Mostapha;

I install Energyplus again but I have this error.What can I do?

Best Regards,

Sajjad

Permalink Reply by sajad shahin on October 7, 2016 at 4:26am

Sorry.this is my file.

Attachments:

q.gh, 509 KB

Permalink Reply by Saeran Vasanthakumar on October 7, 2016 at 2:25pm

I took a look at your file Sajad, and you're using an older version of HB/LB and also seem to be accidently(?) adding the HBZones twice to one of the components. I updated your HB/LB components (for future reference you can use the UpdateHoneybee component to do this) and ran the energy simulation using the openstudio component, and it works.

See file below, let me know if it works.

Attachments:

q_SV_edit.gh, 598 KB

Permalink Reply by sajad shahin on October 13, 2016 at 3:52am

Hi Saeran,

I apologize you for answering late.Unfortunately I couldn't run again and encounter with new errors.

how can I solve it?

Attachments:

1111.png, 213 KB

Permalink Reply by Omid Rashidi on October 13, 2016 at 5:40am

Hi Sajad,

As you probably know this,

In LB & HB components,The "Required" Inputs has only one "_underline" before their names (left side). It is needed to connect all of the _required inputs of components to run. In this attachment, _zonedata (from "Read EP Result component) is not connected, then set boolean to true.

Regards,

-Omid

Permalink Reply by sajad shahin on October 13, 2016 at 6:51am

Hi Omid;

I connected zone data.but it didnt solved.I have the same errors.

Permalink Reply by sajad shahin on October 13, 2016 at 9:35am

Hi again;

I didn't choose any window material for this construction.see my file please.

Regards;

Sajjad.

Attachments:

q_SV_edit.gh, 604 KB

Permalink Reply by Omid Rashidi on October 13, 2016 at 11:41am

Sajad,

Yes, I was tested the file and works fine for me too.

Try to check Saeran's suggestions.

-Omid

Permalink Reply by Saeran Vasanthakumar on October 13, 2016 at 10:01am

Hey Salad, Omid,

I don't think there's anything wrong with the script as its working perfectly fine for me (see img).

Some questions:

- What model units is your Rhino file set to? Should be in meters.

- Where is the origin cplane in your Rhino file, make sure it is as close as possible to your model

- Can you make a simple box and see if the energy simulation works on that? That way we can rule out if there is a geometry issue causing this problem.

Give that a shot, and get back to us.

Attachments: