Grasshopper

algorithmic modeling for Rhino

Interpolate curve

HI!,

I'm trying to make an interpolate curve with three point, one end, middle and start, however it doesn't respect the order, it just goes to the shortlength, conecting them in a diferent order that the one a want.

 

 

If someone could help me could be great!

Views: 975

Replies to This Discussion

Permalink Reply by Danny Boyes on October 21, 2010 at 4:28am
Hi PaUla,

Can you post your GH definition or a screen shot?

Edit: As a guess I think you are probably combining the list of points in the order you want but they have a different path structure and then flattening them in the order they are in the panel shown below.


Danny
Permalink Reply by PaUla on October 22, 2010 at 2:33am
Hi. Danny

I have resolved it, weaving it.
However your advice work!!!!.

Thanks very much.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service